ACV 42xty006 - LFB Citroen/Peugeot/Toyota 10Pin/28Pin multilead loose

Steering Wheel Remote Control Adapter Citroen / Peugeot / Toyota

Retain the original steering wheel remote control functions when replacing the factory radio with an aftermarket radio.
Depending on the vehicle's equipment, as well as the range of functions and software of the aftermarket device, individual control functions may be omitted or replaced by other functions.
Compare the adapter connectors shown with those in your vehicle and ensure that they are visually and technically compatible.
Please also check whether one of the specified original factory radios was installed in your vehicle.
Before final assembly, check the vehicle functions, vehicle settings, and steering wheel remote control for proper functionality.

Note

• analog
• Connector: 10 pin / 6 pin / 20 pin Toyota connector
• Connector: OEM steering wheel remote control > 3.5mm jack / loose cable
• Connector: OEM AUX > Cinch(m) red/black
• To avoid malfunctions or defects on the vehicle or the retrofit device, check the pin assignment by measuring before connection.
• USB > check for correct assignment before installation.
• AUX > Check for correct assignment before installation.
• Dipp switch settings for the retrofit device manufacturer (see BDA)

Suitable for the following vehicles

• Citroen
• Citroen C1 (P) 07/2014 - 09/2021
• Peugeot
• Peugeot 108 (P) 07/2014 - 03/2021
• Toyota
• Toyota Aygo (AB1) 07/2014 - 06/2018
• Toyota Aygo (AB1) 06/2018 - 03/2022

Following Signals are provided.

Reimported vehicles or vehicles with different software may be functionally incompatible.
Steering wheel remote control

General installation instructions

Verification:
1: Check all operating functions and vehicle setting functions of the OEM device.
2: Disassemble the OEM device with the power off.
3: Check all interface connections for correctness and continuity with the power off.

Connection and connection sequence:
1: Make the settings and hardware configuration of the interface with the power off.
2: Configure the Check the radio connection cable
3: Connect the radio connection cable according to the retrofit device's operating instructions
4: Connect all other connections according to the retrofit device's operating instructions
5: Connect the entire installation to the vehicle, making sure the power connection is the last one
6: Configure the interface's software according to the instructions in the article text and in the user manual
7: Configure the retrofit device according to the retrofit device's operating instructions for steering wheel remote control/camera/HFC/antenna phantom power and others
8: Test the steering wheel remote control and vehicle for proper function
Changes to the hardware configuration of the interface and the radio connection cable:
1: Make changes with the power off
2: Connect after changes, see 5 to 8 above

In case of a malfunction of the interface or the vehicle:
1: Revert to the OEM device
2: Operate the OEM device
3: CAN bus idle manufacture
4: Checking the hardware configuration of the Interfaces
5: Connection to CAN bus rest see above 5 to 8

Connections, connection changes, alternative connections, connections of loose cables or connection extensions of loose cables specified in the information text or the operating instructions are intended solely for the guidance and information of trained specialist personnel.

Further connections, changes to the cable configuration of the wiring harness or the use of alternative connections or connection extensions:
1: Connections and modifications may only be carried out by trained specialist personnel.
2: Connections and modifications must be checked before connection for any manufacturer approvals or for any manufacturer warranty conditions that may be affected by the changes.
3: Connections and modifications must be checked for functionality and accuracy before connection by measuring and comparing them with the vehicle's cable assignment plan.
4: Connections and modifications are made at your own risk and without a guarantee of functionality.
5: Connections and modifications are made at your own risk and without a guarantee of damage to the vehicle, the retrofit device, or the interface.
6: Modifications to the pre-assembled wiring harness may void the product's warranty.