ACV 42xpg016 - LFB Citroen/Peugeot/Toyota 10Pin/28Pin Multilead AUX loose

Steering Wheel Remote Control Adapter Citroen/Peugeot/Toyota

Retain the original steering wheel remote control functions when replacing the factory radio with an aftermarket radio.
Depending on the vehicle's equipment, as well as the range of functions and software of the aftermarket device, individual control functions may be omitted or replaced by other functions.
Compare the adapter connectors shown with those in your vehicle and ensure that they are visually and technically compatible.
Please also check whether one of the specified original factory radios was installed in your vehicle.
Before final assembly, check the vehicle functions, vehicle settings, and steering wheel remote control for proper functionality.

Note

• analog
• Connector: 10-pin / 6-pin / 20-pin Toyota connector
• Connector: OEM steering wheel remote control > 3.5mm jack / loose cable
• Connector: OEM AUX > Cinch(m) red/black
• Dipp switch settings for the retrofit device manufacturer (see BDA)

Suitable for the following vehicles

• Citroen C1 (P) 07/2014 - 09/2021
• Peugeot 108 (P) 07/2014 - 03/2021
• Toyota Aygo (AB1) 07/2014 - 06/2018
• Toyota Aygo (AB1) 06/2018 - 03/2022

The following signals are provided

Reimported vehicles or vehicles with different software may be functionally incompatible.
Steering wheel remote control

General installation instructions

Verification:
1: Check all operating functions and vehicle adjustment functions of the OEM device
2: Disassemble the OEM device with the power off
3: Check all interface connections for correctness and continuity with the power off

Connection and connection sequence:
1: Settings and hardware configuration of the interface without voltage
2: Check the configuration of the radio connection cable
3: Connect the radio connection cable according to the retrofit device's operating instructions
4: Connect all other connections according to the retrofit device's operating instructions
5: Connect the entire installation to the vehicle, making sure the power is on last
6: Configure the software of the interface according to the instructions in the article text and in the user manual
7: Configure the retrofit device according to the retrofit device's operating instructions for steering wheel remote control/camera/HFS/antenna phantom power and others
8: Function test of the steering wheel remote control and vehicle

Changes to the hardware configuration of the interface and the radio connection cable:
1: Make changes without voltage
2: For connection after changes, see above 5 to 8

In case of malfunction of the interface or the vehicle:
1: Back to the OEM device
2: Operate the OEM device
3: Establish CAN bus rest
4: Check the hardware configuration of the interface
5: Connection after CAN bus rest, see above 5 to 8

Connections, connection changes, alternative connections, connections of loose cables or connection extensions of loose cables specified in the information text or the operating instructions are for guidance and information purposes only for trained specialist personnel.

Further connections, changes to the cable configuration of the wiring harness or use of alternative connections or connection extensions:
1: Connections and modifications are to be carried out exclusively by trained specialist personnel
2: Connections and modifications must be checked for any manufacturer approvals or for approvals issued by the Changes to potentially affected manufacturer's warranty conditions must be checked.
3: Connections and changes must be checked for function and correctness before connection by measuring and comparing them with the vehicle's cable assignment plan.
4: Connections and changes are made at your own risk and without guarantee of function.
5: Connections and changes are made at your own risk and without guarantee of damage to the vehicle, the retrofit device or the interface.
6: Changes to the pre-assembled wiring harness can void the product's warranty.