ACV 42xsz003 - LFB Suzuki Ignis/Jimny/Swift 20Pin Multilead USB/AUX loose

Steering Wheel Remote Control Adapter Suzuki

Retain the original steering wheel remote control functions when replacing the factory radio with an aftermarket radio.
Depending on the vehicle's equipment, as well as the range of functions and software of the aftermarket device, individual control functions may be omitted or replaced by other functions.
Compare the adapter connectors shown with those in your vehicle and ensure that they are visually and technically compatible.
Please also check whether one of the specified original factory radios was installed in your vehicle.
Before final assembly, check the vehicle functions, vehicle settings, and steering wheel remote control for proper functionality.

Note

• analog
• Connector: 20-pin Suzuki connector
• Connector: OEM steering wheel remote control > 3.5mm jack / loose cable
• Connector: OEM AUX > 3.5 mm jack
• Connector: OEM USB > USB-A
• Dipp switch settings for the retrofit device manufacturer (see BDA)

Suitable for the following vehicles

• Suzuki Ignis (MF) 01/2017 - 04/2021
• Suzuki Ignis (MF) 04/2021 - 08/2024
• Suzuki Jimny (FY) 10/2018 - 09/2020
• Suzuki Jimny NFZ (GJ) 04/2021 - 08/2024
• Suzuki Swift (AZ) 04/2017 - 03/2024

The following signals are provided

Reimported vehicles or vehicles with different software may be functionally incompatible.

Steering wheel remote control

General installation instructions

Verification:
1: Check all operating functions and vehicle setting functions of the OEM device
2: Disassemble the OEM device with the power off
3: Check all interface connections for correctness and continuity with the power off

Connection and connection sequence:
1: Make the settings and hardware configuration of the interface with the power off
2: Check the configuration of the radio connection cable
3: Connect the radio connection cable according to the operating instructions for the retrofit device
4: Connect all other connections according to the operating instructions for the retrofit device
5: Connect the entire installation to the vehicle with the power-carrying connection last
6: Configure the software of the interface according to the instructions in the article text and in the user manual
7: Configure the retrofit device according to the operating instructions for the retrofit device Steering wheel remote control/camera/HFS/antenna phantom power and others
8: Function test of steering wheel remote control and vehicle

Changes to the hardware configuration of the interface and the radio connection cable:
1: Make changes without voltage
2: Connection after change see above 5 to 8

In case of malfunction of the interface or the vehicle:
1: Revert to the OEM device
2: Operate the OEM device
3: Establish CAN bus silence
4: Check the hardware configuration of the Interfaces
5: Connection to CAN bus rest see above 5 to 8

Connections, connection changes, alternative connections, connections of loose cables or connection extensions of loose cables specified in the information text or the operating instructions are intended solely for orientation and information purposes for trained specialist personnel.

Further connections, changes to the cable configuration of the wiring harness or the use of alternative connections or connection extensions:
1: Connections and modifications may only be carried out by trained specialist personnel.
2: Connections and modifications must be checked before connection for any manufacturer approvals or for any manufacturer warranty conditions that may be affected by the changes.
3: Connections and modifications must be checked before connection by measuring and by comparing them with the Check the vehicle's cable assignment plan for functionality and accuracy.
4: Connections and modifications are made at your own risk and without any guarantee of functionality.
5: Connections and modifications are made at your own risk and without any guarantee of damage to the vehicle, the retrofit device, or the interface.
6: Changes to the pre-assembled wiring harness may void the product's warranty.